EUTECH INSTRUMENTS WP PCD 650 Bedienerhandbuch PDF herunterladen (Seite 42)

Instruction Manual PCD 650

2.13.3 Sending readings continuously in single and multi measurement

modes

1. Make sure that the

CURRENT DATA SET parameter is set to ‘TIMED’ in the

System Setup. Set the time interval at which you wish to send the data to

CyberComm (Refer ‘System Settings – Page 4’ on page 79).

2. Make sure the CyberComm 600 application is up and running (page 12).

3. Make sure the IrDA port of the meter is closer and in-line with IrDA port of

the computer.

4. From measurement mode, press PRIN (F3) to send data to CyberComm.

5. In CyberComm screen, press Find Device button.

6. When CyberComm finds the meter, press Connect button. The IrDA link is

established. The measurement readings are sent to CyberComm

continuously at the specified time interval as long as IrDA link is not

disconnected. The transferred readings are displayed in the CyberComm

screen (Figure 33).

7. To stop data transfer, click Disconnect button.

8. To clear the transferred readings in single measurement mode, click Clear

Data button. To clear data in multi measurement mode, select the desired

row and click Clear Data button.

(a) Single measurement mode (b) Multi measurement mode

Figure 33 : Transferring measurement data continuously

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 119 120

Keine Kommentare

EUTECH INSTRUMENTS WP PCD 650 Bedienerhandbuch Seite 42