EUTECH INSTRUMENTS WP PCD 650 Bedienerhandbuch PDF herunterladen (Seite 24)

Instruction Manual PCD 650

Function Keys available in measurement screen (2

Group):

SETP (F1)

Goes to setup mode

MEM (F2)

Shows stored data in the memory

STOR (F3)

Stores the currently displayed reading in the memory

ESC (F4)

Shows 1

Group of functions

Function Keys available in measurement screen (3

Group):

REPO(F2)

Shows corresponding calibration report (based on selected measurement

mode)

PRIN (F3)

Sends the currently displayed reading to the computer through IrDA. (This

key has to be pressed to establish communication with CyberComm PCD

application through IrDA). If data logging mode has been selected in

System Setup then it sends data automatically to meter’s memory.

ESC (F4)

Shows 1

Group of functions

Note: If you press a function key that is not relevant to measurement mode (for

example ENTER, , ) the meter shows ‘Invalid key!’ message in the footer area of

the screen as shown in diagram.

Figure 17: Invalid key

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 119 120

Keine Kommentare

EUTECH INSTRUMENTS WP PCD 650 Bedienerhandbuch Seite 24