EUTECH INSTRUMENTS DO 6 PLUS Bedienerhandbuch PDF herunterladen (Seite 26)

Instruction Manual COND 6+, TDS 6+, SALT 6+

-21-

5.4 Setting the TDS Factor (TDS 6+ only)

The concentration of salts dissolved in solution increases the conductivity. This

relationship varies from salt to salt and is roughly linear over a given range for a given

salt. The TDS conversion factor is the number used by the meter to convert from

conductivity to TDS.

The TDS conversion factor can be set from 0.4 to 1.0. Default value is 0.5.

See Section 13 – Calculating TDS Conversion Factor .

10. Enter advanced setup as described in Section 5.1.

11. Press ▲ or ▼ until [tdS] appears. Press ENTER.

12. Press ▲ or ▼ to select the desired TDS factor.

13. Press ENTER to select and return to the [tdS] setup

function.

14. Press ▲ or ▼ to move to the next setup function or

press CAL to exit to measurement mode.

5.5 Temperature Coefficient

The temperature coefficient is the amount of change in conductivity per degree

temperature (% per °C). For best results, determine and enter the exact temperature

coefficient of your solution. The meter allows adjustment from 0.0 to 3.0 % per °C.

Default value is 2.1 % per °C.

Note: Select 0.0 % for uncompensated measurements. Temperature can be measured

by probe and displayed.

See Section 14 – Calculating Temperature Coefficients.

1. Enter advanced setup as described in Section 5.1.

2. Press ▲ or ▼ until [t.Co %] appears. Press ENTER.

1. Press ▲ or ▼ to select a value between 0.0 to 3.0%.

2. Press ENTER key to select and return to the [t.Co %]

setup function.

1. Press ▲ or ▼ to move to the next setup function or

press CAL to exit to measurement mode.

HOLD

ENTER

HOLD

ENTER

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 39 40

Keine Kommentare

EUTECH INSTRUMENTS DO 6 PLUS Bedienerhandbuch Seite 26